Ambulance Equipment and Electrical-Load Schedule
Estimate diversified ambulance equipment loads and circuit demand before checking battery, generator, oxygen, payload and clinical fit.
Review contacts: Isa and Alicia June.
(clinical load × factor) + (HVAC load × factor) + (support load × factor)Enter every input in the first group. Use 0 only for a confirmed zero quantity.
| Device ID | Device | Quantity | Rated input | Supply | Duty / simultaneous factor | Circuit | Mounting / restraint | Acceptance record |
|---|---|---|---|---|---|---|---|---|
How to use this tool
Record each device separately in the downloadable table; use the calculator only for an early diversified-load check.
- Use manufacturer input ratings and quantities.
- Apply a documented simultaneous-use or duty factor.
- Review starting current, battery autonomy, circuit protection and charging separately.
Keep a record of your inputs
Add the project ID, responsible person, date and revision before using the worksheet to compare suppliers or make a technical decision. Record where each input came from. Leave unknown values open for confirmation; do not fill a gap with an assumed catalogue figure.
The result helps with calculation or recordkeeping only. A competent reviewer must check the units and operating conditions against the selected equipment documents. That review must also cover destination requirements, interactions between systems and the evidence needed at acceptance.
Assumptions and limits
- Starting current, harmonics, autonomy and redundancy are not calculated.
- Clinical commissioning and vehicle electrical acceptance remain separate.